Zenith Block Machine Maintenance Guide

Friends, today we are going to talk about how to take care of this big guy, Zenith block machine. Don't be fooled by its size, it is actually like a delicate old car. If you use it well, it can work for you for ten years, but if you don't use it well, it will get angry every few days.

Things about daily use

Before starting the machine, check these three things: whether the oil level is sufficient (check the scale line for hydraulic oil), whether the air pipe is leaking (listen for a "hissing" sound), and whether the mold is clean (the residue from the last use must be cleaned up).

Remember the "three don'ts" when operating: don't overload (the machine will also get tired), don't adjust parameters randomly (don't think you are an engineer), and don't skip the self-check (the program is not for decoration).

Maintenance secrets are revealed: weekly maintenance includes grease all moving parts (especially guide rails and bearings), check the tightness of the belt (it is suitable to press down 1 cm), and clean the dust in the control cabinet (anti-static!).

Monthly deep maintenance: replace hydraulic oil filter (this money cannot be saved), calibrate pressure sensor (accuracy directly affects brick quality), tighten all machine screws (vibration will loosen screws).

Emergency treatment of common faults

If the Zenith block machine stops suddenly, first check the error code on the control panel (the corresponding solution is in the manual), check whether the emergency stop button is touched, or touch the motor to see if it is hot (hot may be overload).

What should I do if the bricks are not complete? First check whether the mold is worn (change it if necessary), then adjust the feeding amount (too much or too little is not good), and at the same time check whether the hydraulic pressure is sufficient (the standard value is in the manual).

Maintenance precautions

Please prepare the fault photos/videos and recent operation records and machine serial number (sticked on the inside of the control cabinet) before looking for after-sales service.

Remember to turn off the power when you repair it yourself! Put the disassembled parts in order, and clean the contact surface before putting them back.

Summary

Remember three points to use Zenith block machine well: regular maintenance is more important than repair, standard operation reduces faults, and small problems are handled in time to prevent major problems. Machines are also alive. If you treat them well, they will do a good job for you. Don't wait until the machine stops working before you think about maintenance. By then, it will not be a small expense that can solve the problem.

As a professional manufacturer and supplier, we provide high-quality products. If you are interested in our products or have any questions, please feel free to contact us.